The use and maintenance of hydraulic flip plates should adhere to the principle of prevention, and equipment failures should be eliminated in the early stages. Its main task is to prevent loose connections and abnormal wear, and to supervise operators to use the equipment correctly according to the equipment usage regulations. To prevent equipment accidents, extend the service life and maintenance cycle of equipment, ensure the operation of equipment, and provide production equipment in good condition. During the use and maintenance of hydraulic flip plates, the following points should be followed:
1. Strictly follow the operating procedures of the equipment and operate it correctly.
2. In daily work, it is necessary to regularly inspect the loose parts and protective devices of the equipment, and make timely adjustments if there are any problems.
3. Before driving, carefully inspect the equipment. First, check the necessary maintenance parts, and then check the lubrication status of the lubrication parts. If loose connecting bolts are found, they should be tightened in a timely manner.
4. Regularly inspect the wear of the hinge sleeves of each hydraulic cylinder and maintain and replace them in a timely manner.
5. Regularly check the fastening status of the screws on the rear main sleeve seat.
6. After each shutdown, wipe and clean the equipment and working parts to keep them clean, free of oil stains and dirt.
7. Regularly remove equipment rust, spray anti-corrosion paint, and extend equipment life.
8. Regularly inspect the welding seams at each welding point of the equipment, and promptly maintain if cracks or open welds are found.
9. Air filter, hydraulic oil pump outlet inlet filter, clean every six months.
10. Clean the fuel tank once a year.
11. The gearbox needs to be lubricated and replaced once a year.